logo

12 Inch Laser Cut Radial Inflow Turbine by Infinity Turbine

12 Inch Radial Inflow Turbine

12 Inch Radial Inflow Turbine

Radial Inflow 12 Inch Turbine

The IT 10 Redstone Turbine is an experimental turbine designed for small scale power production for the home or low power applications (IT10 1-10 kW).

Project Goals: Make turbine fabrication simple by cutting 2D parts via waterjet or laser, then bolt to plates to form a complete assembly.

Working Fluid: R-245fa, R-134, Compressed Air, pressurized water, and a Stainless Steel version with CO2.

Rapid-Configuration: This assembly allows you to quickly configure turbines and test various working fluids and heat sources. The basic design is for 300 psi or less.

Magnetic Coupling or Large Diameter Gruvlok Pipe Housing Assembly: The unique design has a basic 12 inch diameter which allows for direct-to-motor generator mounting or magnetic coupling and follower, which allows you to have a generator or drive unit mounted exterior.

Plans and licensing available.

12 Inch Radial Inflow Turbine Outer Rotor Foil (pdf)

Email: Radial Inflow Turbine 12 Inch

12 Inch Radial Inflow Turbine Outer Stator

12 Inch Radial Inflow Turbine Outer Stator

Radial Inflow 12 Inch Turbine Outer Stator

Outer stator. 12 Inch Radial Inflow Turbine Outer Stator (pdf)

12 Inch Radial Inflow Turbine Back Plate

12 Inch Radial Inflow Turbine Back Plate

Radial Inflow 12 Inch Turbine Outer Stator

Back Plate. 12 Inch Radial Inflow Turbine Back Plate (pdf)

CONTACT TEL: 608-238-6001 Email: greg@infinityturbine.com | RSS | AMP | PDF | IG | TWITTER